Reports; Menu Settings Page; Event Log; Require Standby - Lexmark C950 Service Manual

Reports

This menu contains informational reports that are helpful when servicing a device.

Menu Settings Page

Print the menu settings pages to list the customer settings and to verify printer options are installed correctly. It
is helpful to print the customer settings before you restore factory defaults or make major changes.
To print the menu settings:
From the Configuration Menu, navigate to Reports > Menu Settings Page.
1.
Printing Menu Settings Page appears, and the pages print.
2.

Event Log

This report lets the system support person print a limited set of the information contained in the Diagnostics
Menu version of the printed Event Log. For a sample of a printout, see
The limited Configuration log and the full Diagnostics log printed versions show the same operator panel
messages when they print and follow the same layout guidelines.
To print the event log:
From the Configuration Menu, navigate to Reports > Event Log.
1.
Printing EVENT LOG appears, and the pages print.
2.

Require Standby

To change this setting:
From the Configuration Menu, navigate to Require Standby.
1.
Touch
2.
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
3.
changes.

Reset Maintenance Counter Value

This setting enables users to reset the selected Maintenance Count value to zero.
To reset:
1. From the Configuration Menu, navigate to Reset Maintenance Counter Value.
From the options displayed, select the maintenance kit to reset.
2.
3. Touch Yes to reset the maintenance counter value. Touch No or Back to return to the previous menu.

Short-edge Printing

This setting enables a user to permit or to prohibit the printing of short-edge oriented paper on the device. The
device's default paper feed orientation is long-edge fed (LEF). However, in order to support added finishing
functionality, the device also supports printing with paper fed in the short-edge (SEF) orientation.
If the setting Disabled (default) is selected, letter and A4 paper can only be fed long-edge. If they are fed short-
edge, a prompt will ask you to use the correct paper size. When the setting is Enabled, you can feed paper
either long-edge or short-edge.
or to change the setting.
"Print the Event Log" on page
Diagnostic aids
5058-030
Previous
Next
Go Back
3-17.
3-11