Lexmark C950 Service Manual page 52

5058-030
User status and attendance messages
User primary message Explanation
Load Manual Feeder
with [size]
Load Manual Feeder
with [paper type] [paper
size]
Load staples
Manual feeder expects
[paper size]. Check
[paper source] guides
Power off, wait 2
seconds, power on
Print quota exceeded.
Print job canceled.
Print quota exceeded.
Print job incomplete.
Remove paper from
standard output bin
Remove paper from bin
[x]
Remove paper from
[linked bin set name]
Remove paper from all
bins
Restore Held Jobs?
Some held jobs were
not restored
Unsupported disk
Service Manual
2-6
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
Try one or more of the following:
• Replace the specified staple cartridge in the finisher.
• Touch Continue to clear the message and continue printing.
• Touch Cancel job to cancel the print job.
Try one or more of the following:
• Load the specified paper size in the manual feeder.
• Physically adjust [paper source] guides to a recognized paper size.
• Touch Continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default source.
Turn the printer off and wait for 2 seconds before turning the printer back on.
The print job has been cancelled because the print quota has been exceeded.
Contact your system support person.
The print job did not complete because the print quota has been exceeded.
Contact your system support person.
Remove the stack of paper from the standard exit bin.
Remove the paper from the specified bin. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove the paper from the specified bin. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove the paper from all of the bins. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Try one or more of the following:
• Touch Continue to restore all held jobs stored on the printer hard disk.
• Touch Do not restore if you do not want any print jobs to be restored.
Touch Continue to delete the specified job.
Note: Held jobs that are not restored stay on the hard disk and are inaccessible.
An unsupported printer hard disk has been installed. Remove the unsupported
device, and then install a supported one.
Previous
Next
Go Back