Installing The Mp-Tp12 Back Box - AMX Modero NXT-1200V Operation/Reference Manual

Installation Procedures: NXD-1200V Panels
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 33). These screws secure
the back box to the internal panel casing.
DO NOT
REMOVE
these
panel
securing
screws
FIG. 33 Location of the attachment screws on the NXD back box
DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure
the LCD to the metallic casing underneath.
7.
Lift the back box housing to separate it from the internal panel casing.

Installing the MP-TP12 Back Box

1.
Unscrew the four pan-head Housing screws (#8-32) from the MP-TP12 rear plastic cover.
2.
Gently place the MP-TP12 back box over the internal panel casing (with the cable routing hole on the
right-side of the panel).
3.
Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the
MB-TP12 back box (FIG. 34) and secure them using a grounded Phillips-head screwdriver.
4.
Place the I/O connector plate back over the connector opening and align the connector locations.
5.
Re-secure the I/O connector plate (using a grounded Phillips-head screwdriver) and re-secure the Stereo
Output nut on the Stereo Output jack.
30
Unscrew these four Housing Screws
to remove the back box. These make direct
contact with the black outer housing.
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
DO NOT REMOVE
these panel
securing screws