Intermec EasyCoder PX4i User Manual page 127

Printhead Replacement, cont.
7
Connect the two cables to the replace-
ment printhead.
9
Close the printhead so the magnet
engages the printhead bracket.
EasyCoder PX4i User's Guide (Fingerprint version)
Chapter 11 — Maintenance
8
Fit the hooks of the printhead bracket
fi ngers onto the headlift shaft. Make
sure that the cables do not prevent the
bracket fi ngers from being properly
seated on the headlift shaft.
10
Load a new supply of media and ribbon,
as described earlier in this manual.
113