Fan-Fold Guides; Media Roll Retainer; 3-Inch Adapter - Intermec EasyCoder PX4i User Manual

Chapter 9 — Options
The rotating edge will cut through the media approx. 37 mm (1.5
inches) in front of the printer's dot line. The media feed should be
adjusted accordingly, see Chapter 7, "Setting Up the Printer."
Should you inadvertently have cut through self-adhesive labels, you will
have to clean the cutting parts. Tilt down the cutter and clean using a
piece of tissue moistened with isopropyl alcohol.
The cutting edge will rotate when the power is switched on
and when the printer is re-booted. Always keep the cutter
in closed position during operation. Switch off the power
or disconnect the cutter before cleaning. Keep your fi ngers
away from cutting parts!

Fan-Fold Guides

The fan fold guides provide a more exact guiding of the media, when the
supply is placed outside the media compartment, for example a stack of
fan-folded tickets. The guides come as an operator-installable kit with
installation instructions. The guides can be fi tted in the upper or lower
slot in the rear plate.
Instructions for loading the media is included in the section "External
Supply" in Chapter 4, "Media Load."

Media Roll Retainer

The media roll retainer is intended for applications where the media may
become misaligned on the media supply hub. The plastic wing-shaped
retainer is simply pressed onto the media supply hub outside the media
roll. Operator-installed, no tools are required.

3-inch Adapter

The 3-inch/76 mm adapter is included in the package and makes it
possible to use media rolls with 3 inch/76 mm inner diameter cardboard
cores.
The adapter is pressed onto the media supply hub and is held in place
by a screw. When fi tting the adapters, make sure that the screw hits a
rounded plastic surface, not a metal leaf spring. Illustrations of how to
load the media using the adapter can be found in Chapter 4.
96 EasyCoder PX4i User's Guide (Fingerprint version)