Intermec EasyCoder PX4i User Manual page 60

Chapter 5 — Thermal Transfer Printing
Ribbon Load, cont.
5a
In case of ribbon 55 to 60 mm (2.16 to
2.3 inches) wide, compress the ribbon
supply bobbin and move it so it snaps
into the fi rst (innermost) groove.
5c
In case of 110 mm (4.3 inches) ribbon
width, compress the ribbon supply
bobbin and move it so it snaps into the
third groove.
46
5b
In case of 88 to 90 mm (3.5 inches)
ribbon width, compress the ribbon
supply bobbin and move it so it snaps
into the second groove.
6
Press the ribbon roll onto the ribbon
supply bobbin (1) and route the ribbon
through the print unit. Pull out 20 cm (8
inches) of ribbon.
EasyCoder PX4i User's Guide (Fingerprint version)