Intermec Shell Overview - Intermec EasyCoder PX4i User Manual

Chapter 8 — Intermec Shell Startup Program
Intermec Shell v8.2 Overview
POWER ON
ENTER=SHELL
5 sec. v.8.2
ENTER=SHELL
4 sec. v.8.2
ENTER=SHELL
3 sec. v.8.2
ENTER=SHELL
2 sec. v.8.2
ENTER=SHELL
1 sec. v.8.2
Last selected
application is started
Default:
Fingerprint 8.30 w. std I/O = "auto"
Legend:
Return to previous menu.
Proceed to next menu.
Accept displayed option
and proceed, or
execute displayed option.
Perform a Testfeed
anywhere in Intermec Shell.
Enter the Setup Mode
from anywhere
in Intermec Shell.
90
SHELL
SEL. APPLICATION
SEL. APPLICATION
CURRENT APPL.
SEL. APPLICATION
Fingerprint 8.30
SEL. APPLICATION
Direct Protocol
Optional application
programs
SEL.APPL rom:
LINE_AXP.PRG
SHELL SETUP:
SETUP SER-COM,UART1
SHELL
PRINT SETUP
SHELL
TESTFEED
SHELL
TEST LABEL
SHELL
ARE YOU SURE?
DEFAULT SETUP
YES=ENTER/NO=ESC
UPDATE:
SHELL
COMPACT FLASH?
SOFTWARE UPDATE
UPDATE:
SHELL
REBOOT FIRMWARE?
Restarts the printer (same as power off/on)
EasyCoder PX4i User's Guide (Fingerprint version)
See the chapter "Setup Mode"
Prints a list of current setup values (test label "Setup Info").
Performs a Testfeed (feeds out a number of blank copies
while autoadjusting the label stop sensor).
Prints test labels "Diamonds", "Chess", "Bar Codes #1", and "Bar Codes #2" in a loop
Press Enter for each new label.
DEFAULT SETUP
PERFORMED
TRANSFER FILE
USING ZMODEM
TRANSFER
COMPLETED
TRANSFER FILE
USING ZMODEM
Last selected application is started
Note: Dotted channels are only shown if
the corresponding optional interface pcb
is fitted.
STD I/O CHANNEL
auto
STD I/O CHANNEL
uart1:
STD I/O CHANNEL
uart2:
STD I/O CHANNEL
uart3:
STD I/O CHANNEL
centronics:
STD I/O CHANNEL
net1:
STD I/O CHANNEL
usb1:
STD I/O CHANNEL
uart4:
STD I/O CHANNEL
uart5:
Printer rebooted
automatically.