Tickets With Black Mark - Intermec EasyCoder PX4i User Manual

Tickets with Black Mark

⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Maximum:
8 dots/mm (203.2 dpi):
11.81 dots/mm (300 dpi): 4,162 mm (163 inches)
provided there is a suffi cient amount of free SDRAM memory
Minimum:
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 12.
⇐ d ⇒ Black Mark Width
Maximum:
Recommended:
Minimum:
⇐ e ⇒ Black Mark Length
Maximum:
Recommended:
Minimum:
⇐ f ⇒ Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of the ticket as possible and use a negative Stop Adjust value to
control the media feed, so the tickets can be properly torn off. The black
mark can be placed either on the top or at the back of the media.
Black Mark Characteristics
Maximum refl ectance:
Difference between mark and media:
Media Type Setup
• Ticket (w mark)
EasyCoder PX4i User's Guide (Fingerprint version)
Appendix B — Media Specifi cations
120 mm (4.72 inches)
25 mm (1.00 inches)
6,143 mm (241 inches)
20.0 mm (0.8 inches)
Full media width
10.0 mm (0.39 inches)
5.0 mm (0.20 inches)
25.0 mm (0.98 inches)
3.2 mm (0.13 inches)
1.27 mm (0.05 inches)
15%, 940 nm
55%
133