Self-Adhesive Labels - Intermec EasyCoder PX4i User Manual

Self-Adhesive Labels

⇐ a ⇒ Media Width (including liner)
Maximum:
Minimum:
⇐ b ⇒ Liner
The backing paper must not extend more than a total of 1.6 mm (0.06
inches) outside the labels and should protrude equally on both side. Rec-
ommended minimum transparency: 40% (DIN 53147).
⇐ c ⇒ Label Width (excluding liner)
Maximum:
Minimum:
⇐ d ⇒ Label Length
Maximum:
8 dots/mm (203.2 dpi):
11.81 dots/mm (300 dpi): 4,162 mm (163 inches)
provided there is a suffi cient amount of free SDRAM memory
Minimum (without LTS):
Minimum (with LTS)
⇐ e ⇒ Label Gap
Maximum:
Recommended:
Minimum:
The Label Stop Sensor must be able to detect the extreme front edges of
the labels.
Opacity
The difference between in opacity between label plus liner and liner only
should be ≥ 19% units.
Maximum liner opacity is 72%.
Media Type Setup
• Label (w gaps)
EasyCoder PX4i User's Guide (Fingerprint version)
Appendix B — Media Specifi cations
120 mm (4.72 inches)
25 mm (1.00 inches)
118.4 mm (4.66 inches)
23.8 mm (0.94 inches)
6,143 mm (241 inches)
8.0 mm (0.32 inches)
12.0 mm (0.47 inches)
25.0 mm (0.98 inches)
3.0 mm (0.12 inches)
1.27 mm (0.05 inches)
129