Cut-Off - Intermec EasyCoder PX4i User Manual

Chapter 4 — Media Load
Cut-Off
The EasyCoder PX4i can print on labels, tickets, tags, and continuous
stock in various forms. This section describes the case when the media is
to be cut off by an automatic paper cutter (option).
Use the <Feed> key (see fi gure #12) when loading the same type of
media s before. When switching to a new type of media or if the printer
does not feed out the media properly, simultaneously press the <Shift>
and <Feed> keys to perform a "testfeed."
Cut-off can be used for:
• Non-adhesive continuous stock
• Self-adhesive labels with liner (cut only liner between labels)
The cutter is designed to cut through paper-based media with a thickness
between 60 and 175 µm, which roughly corresponds to a paper weight
of 60 to 175 grams/m
not be used to cut through labels, because the adhesive will stick to the
shears, which can damage the cutter.
The optional label taken sensor cannot be used with the cutter.
The rotating cutting blade can be accidently activated while
the cutter is open. To avoid any risk of injury to fi ngers,
always switch off the power before loading media and/or
ribbon in a cutter-equipped printer.
24
2 (basis weight 40 to 120 lb.). The cutter should
EasyCoder PX4i User's Guide (Fingerprint version)