Power; Mode; High Altitude; Custom Power Level - Eiki EIP-UJT100 Owner's Manual

Hide thumbs Also See for EIP-UJT100:

Table of Contents

POWER

Default value is Normal.

■ ECO: The wattage of the lamp will be at 360W. If the surrounding environment is

sufficiently dark or if you do not require intense brightness, you can set the lamp to Eco

mode to prolong its usage life.

■ Normal: The wattage of the lamp will be at 465W. If the projection environment requires

brighter picture, you can set the lamp to Normal for the highest projection brightness.

■ Custom Level: If the picture brightness at Eco mode is too dark for you and the Nor-

mal mode gets too bright, you can set it to custom level to specify the power of the lamp

yourself to make fine adjustments to the brightness of the projected picture. You could

encounter situations where the picture from projector A being brighter than projector B.

When this occurs, you can use this function you could encounter situations where the

picture from projector A being brighter than projector B. When this occurs, you can use

this function to fine tune the brightness of the two projectors to achieve consistent pic-

ture brightness. To access this function, go to the OSD Menu → LAMPS → Power

(Custom Level) → Custom Power Level and adjust accordingly.

Note:

ECO is automatically selected between 35~40°C(95~104°F)

Use ◄ or ►function to select single or dual lamp mode.

Use this function to switch the projector's cooling fan for high-altitude circumstances.

You can set it to Off or On. The default setting is Off.

Under normal circumstances, the projector will operate normally with this func-

tion set to Off. If you were to operate the projector in environment of excessive heat

or in areas of high altitude, the projector may automatically shut down due to over-

heat. When this happens, you can enable this function by setting it to On to force the

cooling fan to work at a higher speed to regulate the temperature inside the projector.

Note:

High altitude region refers to area with elevation over 5000 feet

Use this function to fine-tune the brightness. You can set power range from 78.3% to

100%.

Table of Contents