Ac Power Cord Requirement - Eiki EIP-UJT100 Owner's Manual

AC Power Cord Requirement

The AC Power Cord supplied with this projector meets the requirement for use in the
country you purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL)
and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC
line plug. This is a safety feature to be sure that the plug will fit into the power outlet. Do not try to
defeat this safety feature. Should you be unable to insert the plug into the outlet, contact your electri-
cian.
AC Power Cord for the United Kingdom:
This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on
the pin face of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must
be used of the same rating, marked thus ASA. If the fuse cover is detachable, never use the plug
with the cover omitted. If a replacement fuse cover is required, ensure it is of the same colour as that
visible on the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts De-
partment indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet,
it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the
correct plug fitted.
WARNING : A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF EN-
GAGED IN A LIVE SOCKET OUTLET.
The Wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow ......... Earth
Blue .............................. Neutral
Brown ........................... Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured
markings identifying the terminals in your plug proceed as follows: The wire which is coloured green-
and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the
safety earth symbol or coloured green or green-and-yellow. The wire which is coloured blue must
be connected to the terminal which is marked with the letter N or coloured black. The wire which is
coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
WARNING: THIS APPARATUS MUST BE EARTHED.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY
ACCESSIBLE.
11