Table of Contents
Advertisement
■ Top: Use◄► to adjust the top blanking area on the projected image.
Adjustable from 0 to 360
■ Bottom: Use ◄► to adjust the bottom blanking area on the projected image.
Adjustable from 0 to 360
■ Left: Use ◄► to adjust the left blanking area on the projected image.
Adjustable from 0 to 534
■ Right: Use ◄► to adjust the right blanking area on the projected image.
Adjustable from 0 to 534
■ Reset: Set all the values to 0.
Edge Blend
Edge blend function allows multiple projector images to be seamlessly overlapped. To
use this function, Edge Blend must be enabled on both projectors.
■ Status: Press ENTER to select ON or OFF. The function must be set to ON in order to
enable the function of Edge blend. If the function is set to OFF, the function of Edge
blend is disabled.
■ White Level: White level is to used to set the overlapped area at the four sides for
blend in multi-projection application. Adjusted lines, when enabled, will be shown for
indicating the overlapped area boundary. Press▲▼◄► to adjust the white level at Top,
Bottom, Left, Right directions on the projected picture.
As shown in the below drawing, the white level area is the overlap area of the projected picture 1 and
the projected picture 2. The white level lines that is set where the other projector last pixels ends.
■ Black Level: The outward boundaries of overlapping edges might appear brighter than
the rest of the image due to the lumen at the inactive DMD display area. The purpose
of black level is compensate the non overlap area vs the overlap area. It increases the
black level of non overlap area .It is used to adjust the black level at Top, Bottom, Left,
Right directions on the projected pictures.
After selecting and configuring the black level adjustment area, each of the primary
colors Red, Green, Blue can be adjusted to increase to a higher black level
independently, or optionally All colors together can be adjusted to increase to a higher
black level simultaneously.
Note:
The function combination of Black Level adjustment , 4 Corners and blend along comers is not avail-
able.
Note:
DVI-D (3D DVI) has not supported Edge Blend.
51
Advertisement
Table of Contents
