Table of Contents
Advertisement
You can choose different input sources on the projector, namely: HDBaseT, HDMI,
DVI-D, VGA, Y/Pb/Pr, 5 BNC, 3G-SDI.
Factory default setting refer to
Note:
DVI-D (3D DVI) has not supported PIP, Warp, Edge Blend.
After factory reset, the input button will be back to default.
Trigger 1, 2
The projector comes with one set of Trigger output. You can configure one devices con-
nected to the projector via the trigger port to be automatically turned on when the projector
is on. There will be a 2-3 second delay prior to activation to prevent operation of this func-
tion when the user is choosing an aspect ratio.
■ 5:4: Outputs 12V of power on Trigger when Aspect Ratio is set to 5:4.
■ 4:3: Outputs 12V of power on Trigger when Aspect Ratio is set to 4:3.
■ 16:10: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:10.
■ 16:9: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:9.
■ 1.88: Outputs 12V of power on Trigger when Aspect Ratio is set to 1.88.
■ 2.35: Outputs 12V of power on Trigger when Aspect Ratio is set to 2.35.
■ Letterbox: Outputs 12V of power on Trigger when Aspect Ratio is set to Letterbox.
■ Native: Outputs 12V of power on Trigger when Aspect Ratio is set to Native.
■ Unscaled: Outputs 12V of power on Trigger when Aspect Ratio is set to Unscaled.
■ Auto: Outputs 12V of power on Trigger automatically.
Auto Source
When set to ON the projector will automatically determine the source of input every time
it is turned on so that the user will not have to make the selection on the OSD Menu.
Setting the function off will require the user to specify source of picture input on the OSD
Menu in order for the projector to display the intended picture.
Note:
This function is not available when the input source is 3D DVI.
Language
Set the OSD language. Refer to
page 17 button 1-5.
Page 33 Changing the OSD Language
55
Advertisement
Table of Contents
