Table of Contents
Advertisement
Network
To control the projector via network, after connecting the network cables for a PC and
the projector, you can use this OSD function to view the relevant network information (such
as IP Address, Subnet Mask, Gateway and DHCP) of the projector. Please configure the
PC to be connected to the projector with a proper IP address with the same subnet mask,
gateway as the projector. The default IP address of the projector is 192.168.0.100. The
network settings of the projector can only be changed through the web-page control or se-
rial commands.
To control the projector via network, please connect to the projector via a web browser
with the IP address shown on the OSD menu System -> Network.
Menu Position
Set the OSD pop on the screen's position. The default setting is "Center".
Top Left
Bottom Left
Start Up Logo
Use◄► select on or off of the start up logo.
Start Up Chime
Set it to On to have the projector play a sound effect during start up; when it is set to off,
the projector will not play any sound effect to indicate start up.
Button 1~5
Use this function to set the picture source for each corresponding button.
For example, if you have assigned Button 1 as HDMI and Button 2 as VGA, when you
press
on the remote control, the projector will show the picture from HDMI. And when
1
you press
on the remote control, the projector will switch to the picture from VGA.
2
Top Right
Bottom Right
Center
54
Advertisement
Table of Contents
