Table of Contents
Advertisement
Note:
*In most situations, you can simply point the remote control at the screen which will reflect the IR sig-
nal from the remote back toward the IR receiver on the projector. In some cases, however, ambient
light may prevent this. If so, try again.
*If the effective range of the remote control decreases, or it stops working, replace the batteries with
new ones.
*The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or
fluorescent lighting.
Remote Control Battery Installation
1. Slide the battery cover to remove it.
2. Install two AA(2) batteries with the correct polarity.
3. Put back the cover.
Note:
*Make sure that the battery polarities are correct when installing the batteries.
*Do not mix an old battery with a new one or different types of batteries.
*Avoid contact with water or liquid.
*Do not expose the remote control to moisture or heat.
*Do not drop the remote control.
*If you will not use the remote control for a long time, remove the batteries to avoid damage from bat-
tery leakage. Please wipe the remote control clean and install new batteries if the battery is leaked.
*Dispose of used batteries according to the instructions or your local disposal rule or guideline.
1
2
18
3
Advertisement
Table of Contents
