Safety Instructions - Eiki EIP-UJT100 Owner's Manual

Safety Instructions

All the safety and operating instructions should be read before the product is operated,
and retain the owner's manual for later use.
Do not use the equipment near water.
The projector should never be covered with cloth or other materials, and the openings
should not be blocked by placing the projector on unstable surface like a bed, sofa and
rug.
Do not install the equipment near the thermal source, such as the heater, radiator, and
furnace or other equipment that will generate heat (including the amplifier).
Do not install the projector near the ventilation duct of air conditioner.
This projector should be operated only from the type of power source indicated on the
marking label. If you are not sure of the type of power supplied, consult an authorized deal-
er or local power company. Do not allow anything to rest on the power cord.
Do not overload wall outlets and extension cords as this can result in fire or electric
shock.
Do not destroy the safety protection function of polarized or grounding plugs as this can
result in fire electric shock or causing projector damaged. If the provided plug does not
match the outlet, contact an electrician to change the old one.
Prevent the power cord from being treaded or pressed, especially the power cord near
the plug, outlet and the connection between the power cord and the equipment.
Unplug the power cord during a lighting or when the equipment is not used for long peri-
ods.
Do not stare directly at the lens when the projector is running.
Do not attempt to service this projector yourself as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all servicing to qualified service
personnel.
When replacement parts are required, be sure the service technician has used replace-
ment parts specified by the manufacturer that have the same characteristics as the original
part. Unauthorized substitutions may result in fire, electric shock, injury to persons or pro-
jector damaged.
The +12V trigger only outputs 12V DC trigger signal. Do not connect to other power in-
put or output. Otherwise, the equipment may be damaged.
Blocking the air vents by dust and leaving the projector uncleaned for a long time may
cause a breakdown, damage the projector or accidents. Please clean or change the filters
regularly. The packaging materials should be kept properly for the use of transportation.
8