Table of Contents
Advertisement
A black image is required to connect to the multiple projectors to be blended for the black level adjust-
ment. For projector projecting Image 1, Set the adjustment line of the black level to the position where
the in active DMD's of another projector ends, for example: Adjust black level of projector correspond-
ing to Image 1 to match the black level of inactive DMD display area of another projector. And per-
forming the same adjustment on the projector corresponding to Image 2.
■ Reset: Set all the value to 0.
■ Adjust Lines: When the function is ON, there will be adjust lines on the picture in order
to easily adjust multiple pictures. Press ▼▲◄► on the remote control to adjust the
position of the lines on the picture.
Note:
When the "ON" is selected, the adjustment lines appear for blending adjustment. After the adjustment
has been done, do not forget to select "OFF" to erase the green lines.
White Level Lines
Image 1
Area for black
level increase
adjustment
Increase
Black Level
black level
Width (Right)
52
Image 2
White Level
Width(Right)
Advertisement
Table of Contents
