Osd Introduction - System; Ir Address; Eco Network Power - Eiki EIP-UJT100 Owner's Manual

Hide thumbs Also See for EIP-UJT100:

Table of Contents

OSD Introduction – SYSTEM

If control two projectors with one remote control, you can set one projector IR Address

code to "1" and "2" for the other projector. You can control two projectors with the same re-

mote control just need to change the IR Address 1 or 2.

Selecting the ECO network disable the LAN function.

When this function set to ON, the projector will turn off the power that control the the LAN

board. So you can't operate the projector remotely over a network at the standby mode.

If set to OFF, you won't conserve power but can control the projector remotely over a

network.

Table of Contents