Connecting The Ac Power Cord - Eiki EIP-UJT100 Owner's Manual

Hide thumbs Also See for EIP-UJT100:

Table of Contents

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-240 VAC. It is designed to work with

single-phase power systems having a grounded neutral conductor.

1. Connect the necessary signal cable.

2. Select the correct voltage 115V or 230V.

3. Connect the AC Power Cord.

4. Secure the power plug by locking the plug holder clamp.

To reduce the risk of electrical shock, do not plug into any other type of power system.

If you are not sure of the type of power being supplied, consult your authorized dealer or

service center. Connect the projector with all peripheral equipment before turning on the

projector.

Note:

Unplug the AC power cord or turn off the MAIN ON/OFF Switch when the projector is not in use and

the projector is in stand-by mode, it consumes a little electric power.

VOLTAGE SELECT

Select 115V or 230V

AC IN

Table of Contents