Connecting The Ac Power Cord - Eiki LC-WB200W Owner's Manual

This projector uses nominal input voltages of
100-240 V AC and it automatically selects the
correct input voltage. It is designed to work with
single-phase power systems having a grounded
neutral conductor. To reduce the risk of electrical
shock, do not plug into any other type of power
system.
If you are not sure of the type of power being
supplied, consult your authorized dealer or
service center.
Connect the projector with all peripheral
equipment before turning the projector on.
CAUTION
The AC outlet must be near this equipment
and must be easily accessible.
 Note:
Unplug the AC power cord when the projector is not in use. When this projector is connected
to an outlet with the AC power cord, it is in Stand-by mode and consumes a little electric power.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
For the U.S.A. and Canada
To power cord
connector on your
projector.
Connecting the AC Power Cord
Ground

To the AC outlet.
(120 V AC)
Connect the AC power cord
(supplied) to the projector.
AC outlet side
For Continental Europe
To the AC outlet.
(200 - 240 V AC)
Installation
For the U.K.
Ground

To the AC outlet.
(200 - 240 V AC)
17