Connecting The Ac Power Cord - Eiki LC-WAU200i Owner's Manual

Connecting the AC power cord

This projector uses nominal input voltages of
100–240V AC and it automatically applies to
different input voltages. It is designed to work
with a single-phase power system having a
grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other
type of power system. If you are not sure of
the type of power being supplied, consult your
authorized dealer or service center. Connect
the projector with all peripheral equipment
before turning it on.
Note:
The AC outlet should be near this equipment and must be easily accessible.
 Note:
For safety, unplug the AC power cord when the projector is not in use. When the projector is connected to an
outlet with AC power cord, it is in stand-by mode and consumes a little electric power.
Note on the power cord
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC
plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord
does not match.
Projector side
To power cord
connector on your
projector.
√ Note:
● Using incorrect power cord may influence the product performance, or even cause hazards like an
electric shock or fire. To ensure the product performance and security, please apply the cable of the
same model with the original one.
● Common connecting cables include the AC power cord, various VGA cables, video cable,and serial
control cable.
For the U.S.A. and
Canada
Ground
To the AC outlet.
(110 V AC)
Connect the AC power cord
to the projector.
AC outlet side
For Continental
Europe
To the AC outlet.
(200 - 240 V AC)
Installation
For the U.K.
Ground
To the AC outlet.
(200 - 240 V AC)
19