Digital Instrument, Warning Lights (Te) - Husqvarna TE 250 - 310 2011 I.E. Specifications - Operation - Maintenance

DIGITAL INSTRUMENT, WARNING LIGHTS (TE)

The motorcycle is equipped with a digital instrument; on the in-
strument are located 3 warning lights too: high beam, blinkers
and fuel reserve.
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "BLINKERS"
3- ORANGE warning light "Fuel reserve"
(2,3 l - 2.02 Imp. qt - 2.43 U.S. qt)
Turning the ignition key to the position "IGNITION" the instrument
display illuminates (amber colour).
NOTES
- When linked to the battery, for the first 2 seconds, the instru-
ment shows the version of the checking SW; after the check,
the instrument shows the last planned function.
- When the motorcycle engine is OFF, the instrument doesn't
also show its functions.
- To select the instrument functions and to set to zero the fun-
ctions, use the SCROLL knob (A).
EN - 12
- The instrument functions are the following, as shown below.
1- SPEED / ODO (figure 1)
2- SPEED / CLOCK (figure 2)
3- SPEED / TRIP (figure 3)
4- SPEED / CHRONO (figure 4)
5- SPEED / RPM (engine r.p.m. numerical value) (figure 5)
1- SPEED / ODO (figure 1)
.................
IMPORTANT:: in case of FUEL INJECTION SYSTEM malfun-
ction on the right side of the instrument display will be displayed
the warning message "FAIL": (see page 14): in this case
contact your local HUSQVARNA Dealer.
1- SPEED (Km/h or mph) / ODO (figure 1)
- SPEED: motorcycle speed- maximum value: 299 Km/h or 299
mph;
- ODO: odometer- maximum value: 99999 km;
To replace kilometers with miles or miles with kilometers pro-
ceed as follows:
1) set to figure 1, stop the engine and push the knob SCROLL
(A);
2) turn the ignition key to the IGNITION position, holding pu-
shed the button SCROLL (A) until the symbol "Km/h" will be
displayed;
3) then the symbols "Km/h" and "Mph Miles" will be displayed
alternatively. Push again the SCROLL (A) button when the
unit you wish to use is displayed.