Simplified Audio Schematic - Shure DCS 6000 User Manual

DCS 6000 Digital Conference System
3. LAN (TCP/IP) connector – A RJ45 connector
for connection to local area network (LAN).
This connector is used to connection to the
built in web application or for connection to SW
6000 or a control system like AMX® or
Crestron®.
4. Audio output A, B, C, D, E, F & H – Eight
male XLR3 connectors for connection of PA
systems, Audio Mixers, Audio Recorders or
Language Distribution System etc.
5. Audio input In 1 & In 2 – Two female XLR3
connectors for extra audio inputs. 'In 1' and 'In
2' is used to connect auxiliary symmetrical
audio signals such as a wireless microphone to
the floor language.

Simplified Audio Schematic

Figure 0-A
'In 2' is also used for connection of an
'Emergency Evacuation Message (EEM)'
audio signal.
6. Emergency switch connector – A
terminal block socket for a single, 'normally
open' switch. When the switch is closed, the
audio signal on the 'In 2' connector is
distributed on all output channels and
loudspeakers, overriding all other audio
inputs.
Note: There is no volume control available for setting
the EEM volume on 'In 2'. The volume has to be set
at the equipment generating the "Emergency
Evacuation Message (EEM)" audio signal.
CU 6110 Central Unit Audio Schematic
15
User Manual