DCS 6000 Digital Conference System
The CU responds to this command by returning an 'audio_path' command.
Set Individual Speaker Attenuation
This command is only available on CU 6110
mic_speaker_attenuation <seat_number> <Attenuation><CR>
This command sets the speaker attenuation of a microphone.
<seat_number>: The microphone to adjust
<Attenuation>: The desired speaker attenuation. Possible values: 0 to 7.
0 to 6 will attenuate 0 to 6 dB. 7 is speaker off.
The CU responds to this command by returning a 'mic_speaker_attenuation' message.
Set Individual Microphone Attenuation
This command is only available on CU 6110
mic_attenuation <seat_number> <Attenuation><CR>
This command sets the attenuation of a microphone.
<seat_number>: The microphone to adjust
<Attenuation>: The desired microphone attenuation. Possible values: 0 to 6 dB, where 0 is the lowest
attenuation and 6 is most attenuation.
The CU responds to this command by returning a 'mic_attenuation' message
Request audio status
audio_status<CR>
System audio status.
The CU responds to this command by returning a list of commands for the Audio settings:
line_output_volume
audio_path
line_input_level
line_input_gain
mic_speaker_attenuation
mic_attenuation
loudspeaker_volume
audio_status_done
Commands from CU 6110 to External
Loudspeaker volume
loudspeaker_volume <volume><CR>
Volume of loudspeakers for all Conference units.
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas
values from -40 to 0 indicates attenuation in dB.
Line input 1 level
line_input_level_1 <level><CR>
(for all outputs)
(for all paths)
(for all inputs)
(for all inputs)
(for all units)
(for all units)
65
User Manual