Audio Control; External Commands To Cu 6110 - Shure DCS 6000 User Manual

DCS 6000 Digital Conference System
•
When the external control application requests microphone status (mic_status).
•
When a microphone unit becomes lost or found
<seat number> The seat number identification of a microphone unit. An integer ranging from 1 to
65535.
<seat state> The current state of the seat. This can be "active" or "passive"
<name> The seat name or delegate name. If a delegate name is available for the seat number then the
delegate name is provided. Otherwise the seat name is provided.
Example:
seat_number 12 active John Jones<CR>
This command informs about seat number 12, which is active and has the name 'John Jones' attached.
Microphone status complete
mic_status_done<CR>
Informs, that complete system status has been sent.
Command error
command_error <error text><CR>
The CU has received an unknown command.
<error text> is a text explaining the fault case.
Example:
command_error unknown command<CR>
command_error syntax error<CR>

Audio Control

External Commands to CU 6110

Set loudspeaker volume
loudspeaker_volume <volume><CR>
Set the volume of loudspeakers for all Conference units.
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas
values from -40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a 'loudspeaker_volume' command.
Set line input 1 level
line_input_level_1 <level><CR>
Adjust the level of line input signal.
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from
-40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a 'line_input_level_1' command.
63
User Manual