Getting Started; Setting Up The System The First Time; Connecting A Pc - Shure DCS 6000 User Manual

DCS 6000 Digital Conference System

Getting Started

Setting up the system the first time

When setting up the system for the first time
please follow the instruction given in this section in
sequence.
1. Unpack the CU 6110 Central Unit and
connect the power cord to the CU Power
Supply and connect the cable from the power
supply to the CU 6110.
Please refer to section 'CU 6110 Central Unit'
for details.
2. Place all units at the positions, where they
are to be used observing the unit type.
3. Connect the GM Gooseneck Microphone to
the units. If needed fix the gooseneck
microphones to the units with the tool
delivered with the CU 6110.
4. Connect the units to one or two of the DCS-
LAN connectors on the CU 6110 using EC
6001-xx Cat5e extension cables in suitable
length observing that the cables are not
bended to a radius less than 15 mm.
Please refer to section '

Connecting a PC

When connecting a PC direct to the CU 6110
please follow the instruction given in this section in
sequence.
1. Connect the PC and the CU 6110 with a
standard LAN cable
2. Turn 'On' power to both units
3. On the PC check that the network setting is
set to 'Obtain an IP address automatically':
a. Navigate to 'Control Panel * Network and
Sharing Center * Change adapter settings
* Local Area Connection'.
b. Select 'Properties'
c. Select 'Internet Protocol Version 4
(TCP/IPv4)'
d. Click 'Properties'
e. Change setting to 'Obtain an IP address
automatically'
General Guidelines' for details.
5. Connect power to the PS CU Power
Supply. The light indication in the power
switch on the CU 6110 will light red.
6. Activate the power switch on the CU 6110
and the light indication in the button will
light green. After about 15 seconds, the
display in the CU will be visible and the
LED's in the conference units will flash
until the units are registered (less than 60
seconds).
7. Check that the units are working by
activation the 'Speak' button.
8. Adjust the 'Loudspeaker volume' to a
desired level using the interactive menu
on the front of the CU 6110.
Please refer to the section 'Using the
Interactive Menu' for details.
4. Using the interactive menu on the CU
6110 navigate to:
a. 'LAN setup * Acquire IP adr.'
b. Select 'Dynamic'.
5. Using the interactive menu on the CU
6110 navigate to:
a. LAN setup * IP address setup * IP
address * Actual IP address
b. Note the IP address
6. Open the internet browser in the PC
7. Type in the internet browser: 'http://IP-
address', where 'IP address' is the address
noted from the CU 6110
8. The CU 6110 browser interface will open.
Please refer to section 'Web Browser Setup and
Control' for details about using the CU 6110
web browser.
9
User Manual