Shure DCS 6000 User Manual page 64

DCS 6000 Digital Conference System User Manual
Set line input 2 level
line_input_level_2 <level><CR>
Adjust the level of line input signal.
<level> The level of line input 2 ranges from -41 to 0. The value -41 indicates Off, whereas values from
-40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a 'line_input_level_2' command.
Set line input 1 gain
line_input_gain_1 <gain><CR>
Adjust input gain of the line in 1 input.
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10
dB gain to the line input.
The CU responds to this command by a line_input_gain_1 message.
Set line input 2 gain
line_input_gain_2 <gain><CR>
Adjust input gain of the line in 2 input.
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10
dB gain to the line input.
The CU responds to this command by a line_input_gain_2 message.
Set line output volume (A-H)
line_output_volume <output> <volume><CR>
Adjust the level of line output signal.
<output> Indicates which output is being controlled. Possible values: 'A', 'B', 'C', 'D', 'E', 'F', 'G', 'H'.
Note: CU 59XX and CU6105 support A to D. CU6110 supports A to H.
<volume> The volume of line output ranges from -41 to 0. The value -41 indicates Off, whereas values
from -40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a 'line_output_volume' command.
Define audio path
audio_path <path> <on/off><CR>
This command defines audio connections in the system.
<path> Indicates which connection is being controlled. Possible values: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A', 'linein_1_to_floor', 'linein_2_to_speaker',
'linein_2_to_lineout_A', 'linein_2_to_floor'.
Note: CU 59XX do not support the linein_2 values.
<on/off> Indicates, whether the audio is being routed from microphones/lineinput_1 to
speakers/lineoutput/floor.
64