Voting Control; External Commands To The Cu 6110 - Shure DCS 6000 User Manual

DCS 6000 Digital Conference System
Individual Speaker Attenuation
mic_speaker_attenuation <seat_number> <Attenuation><CR>
Indicates the speaker attenuation of a microphone. Only available on CU 6110.
<seat_number> The microphone that has been adjusted
<Attenuation>: The desired speaker attenuation. Possible values: 0 to 7.
0 to 6 will attenuate 0 to 6 dB. 7 is speaker off.
Individual Microphone Attenuation
mic_attenuation <seat_number> <Attenuation><CR>
This message indicates the attenuation of a microphone. This message is only available on CU 6110.
<seat_number>: The microphone that has been adjusted.
<Attenuation>: The microphone attenuation. Possible values: 0 to 6 dB, where 0 is the lowest
attenuation and 6 is most attenuation.
Audio status complete
audio_status_done<CR>
This command terminates audio status streaming.

Voting Control

External Commands to the CU 6110

Start a voting session
start_voting <voting_session_id><CR>
Starts a voting session in the CU
<voting_session_id>: Identification of the voting configuration to start.
The CU replies with 'voting_started', if a voting session is started.
SW 6000 controlled
The voting_session_id defines which voting configuration to run. A list of configurations can be
requested by command 'voting_status'.
If no voting_session_id is specified, the default SW 6000 voting configuration is requested.
Standalone
voting_session_id defines the build-in voting configurations:
'1' 3-button voting
'2' 3-button secret voting
'3' 5-button voting
'4' 5-button secret voting
If no voting_session_id is specified, the configuration '1' is requested.
Stop a voting session
stop_voting<CR>
Used to stop an ongoing voting session in the CU. If the voting session is stopped, the CU replies with
'voting_stopped'.
67
User Manual