DCS 6000 Digital Conference System
Connecting an emergency signal
To use the emergency signal function, a switch
(normally-open) must be connected to the
emergency switch connector. When the switch is
closed an "Emergency Evacuation Message (EEM)"
audio signal present on the 'In 2' input is
Using the Interactive Menu
Overview
The major configurations and operation options of
the CU 6110 can be set via an interactive menu,
using the 2x20 character OLED display and the 5-
button keypad.
'Figure 5.3 A' gives an overview of the menu
structure, however for a general description of the
settings in the menu refer to the section 'Web
Browser Setup and Control' where all CU 6110
settings are explained.
distributed to all output channels, overriding all
other audio inputs.
Important: The level of the signal must be
controlled externally.
Figure 0-A
Menu overview
Navigate through the menu
Navigation in the menu and changing
parameters is done by activation the 5-button
keypad:
Cycle through the menu items (Blue
marking) with the four 'arrow' buttons (Left-
Right, Up-Down).
Navigate to a settable option (Green
marking).
Cycle through the available values for a
settable option using the 'arrow' buttons Up-
Down.
Press the 'Enter' button in the center to accept
the value. Pressing the Enter button concludes
the selection made, and at the same time it
indicates a confirmation of the possible changes
made within the selection.
Please note that some changes are applied
immediately but might not be saved. Saving of
those settings to the memory of the CU 6110
will be done within 15-30 seconds.
23
User Manual