Simplified Audio Schematic - Shure DCS 6000 User Manual

DIS Digital Conference System
Connecting a LAN (TCP/IP) connection from a third
part device to this output may damage both the third
part device and the CU 6110.
3. LAN
connector for connection to local area
(TCP/IP)
network (LAN). This connector is used to
connection to the built in web application or
for connection to SW 6000 or a control
system like AMX® or Crestron®.
4. Audio output A, B, C, D, E, F & H – Eight
male XLR3 connectors for connection of PA
systems, Audio Mixers, Audio Recorders or
Language Distribution System etc.
5. Audio input In 1 & In 2 – Two female XLR3
connectors for extra audio inputs. 'In 1' and
'In 2' is used
6.2

Simplified Audio Schematic

– A
connector
to connect auxiliary
Figure 6.2-A
User Manual CU 6110 rev A.docx
symmetrical audio signals such as a wireless
microphone to the floor language.
'In 2' is also used for connection of an
RJ45
'Emergency Evacuation Message (EEM)'
audio signal.
6. Emergency switch connector – A terminal
block socket for a single, 'normally open'
switch. When the switch is closed, the audio
signal on the 'In 2' connector is distributed
on all output channels and loudspeakers,
overriding all other audio inputs.
Note: There is no volume control available for setting the
EEM volume on 'In 2'. The volume has to be set at the
equipment generating the "Emergency Evacuation Message
(EEM)" audio signal.
CU 6110 Central Unit Audio Schematic
User Manual
17