Sending Audio From A Shure Device; Receiving Audio From A Device Using A Different Audio Network Protocol; Paint Square Array Microphones; Step 1: Remove The Frame And Grille - Shure MXA902 Manual

• Before turning encryption on or off, you must disable AES67 in Dante Controller.
• AES67 cannot operate when the transmit and receive devices both support Dante.
Shure Device Supports:
Dante and AES67
Dante and AES67
Separate Dante and AES67 flows can operate simultaneously. The total number of flows is determined by the maximum flow
limit of the device.

Sending Audio from a Shure Device

All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
1. Open the Shure transmitting device in Dante Controller.
2. Enable AES67.
3. Reboot the Shure device.
4. Create AES67 flows according to the instructions in the

Receiving Audio from a Device Using a Different Audio Network Protocol

Third-party devices: When the hardware supports SAP, flows are identified in the routing software that the device uses. Oth­
erwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices: The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.

Paint Square Array Microphones

You can paint the grille and frame of square ceiling array microphones to blend in with a room's design.
Note: Don't remove any of the screws on the MXA902's loudspeaker enclosure while painting.

Step 1: Remove the Frame and Grille

1. On each side of the frame, remove the 6 screws and washers that attach the main assembly to the frame.
Important: Do not remove the 4 recessed screws in each corner.
Device 2 Supports:
Dante and AES67
AES67 without Dante. Any other au­
dio networking protocol is acceptable.
Dante Controller user
AES67 Compatibility
No. Must use Dante.
Yes
guide.
Shure Incorporated
29/38