Terminating the Link
Terminate the link by installing a 120 ohm, 1/4 watt (minimum) terminator in the fixture's Data
Out (female) cable connector in the last fixture on each DMX link.
To construct a terminator:
1. Disassemble a male 3-pin or 5-pin XLR connector.
2. Solder a 120 ohm resistor, minimum of 1/4 watt,
between Pin 2 and Pin 3.
3. Reassemble the XLR connector.
SHAPESHIFTER User Manual
SHAPESHIFTER Setup and Configuration
CHAPTER 2
11