Led4 X Er; Led4 Y Er; Led5 X Er; Led5 Y Er - High End Systems Shapeshifter C1 User Manual

LED4 X Er

(LED4 X -error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED4 X is not located in the default position after the reset.

LED4 Y Er

(LED4 Y - error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED4 Y is not located in the default position after the reset.

LED5 X Er

(LED5 X -error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED5 X is not located in the default position after the reset.

LED5 Y Er

(LED5 Y - error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED5 Y is not located in the default position after the reset.

LED6 X Er

(LED6 X -error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED6 X is not located in the default position after the reset.

LED6 Y Er

(LED6 Y - error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED6 Y is not located in the default position after the reset.

LED7 X Er

(LED7 X -error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED7 X is not located in the default position after the reset.

LED7 Y Er

(LED7 Y - error) This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its
driving IC on the main PCB). The LED7 Y is not located in the default position after the reset.
SHAPESHIFTER User Manual
General Maintenance and Troubleshooting
CHAPTER 6
49