High End Systems Shapeshifter C1 User Manual page 18

CHAPTER 2
SHAPESHIFTER Setup and Configuration
WARNING!
In all cases a safety cable should also be fixed between the safety cable
mounting holes located at the bottom of the fixture base housing and the truss.
Failure to use a safety cable could result in injury or death. High End Systems
supplies the proper safety cables and may be contacted for replacements if
necessary. For more information go to: www.highend.com/trusshang
Use the following steps to mount a SHAPESHIFTER fixture on a standard truss:
1. Fix the clamp on the bracket by tightening the M12 screw on the bracket to the hole in the
center of the bracket.
2. Insert the quick-lock fasteners of the first Omega holder into the respective holes on the
bottom of the fixture. Tighten the quick-lock fasteners fully clockwise.
3. Install the second Omega holder.
4. Pull the safety-rope through the holes on the bottom of the base and over the trussing system
or a safe fixation spot. Insert the end in the carabine and tighten the safety screw.
1. Omega-holders
2. Clamp
3. Safety Cable
4. Quick-lock fastener
8 SHAPESHIFTER User Manual