Control - High End Systems Shapeshifter C1 User Manual

Control

The Control parameter allows remote control of Display, Homing, Module Lamp and Shutdown.
Note: To access all control settings, first select a control channel value, then
set the Shutter channel to DMX = 0.
Control Setting
Safe
Pan and Tilt MSpeed Off
Display/LEDs Off
Display/LEDs Bright
Home All
Shutdown
Module X Invert On
Module X Invert Off
Module Y Invert On
Module Y Invert Off
Module XY Swap On
Module XY Swap Off
SHAPESHIFTER User Manual
DMX
Value
0-5 Disables all Control settings for normal operation
16-31 Disables MSpeed
32-47 Turns display and all LED modules off
48-63 Turns display and all LED modules fully on
64-79 Remotely homes all the fixture components
Remotely shuts down the fixture. When a fixture is shut down, the LEDs
80-95 are off and power to the motors is disabled. If a fixture is in shutdown
mode, the fixture must be homed to bring it back into operation.
112-127 This menu option inverts the direction of the Module X motor operation to
coordinate movements between SHAPESHIFTER fixtures mounted
128-143
opposite each other horizontally.
144-159 This menu option inverts the direction of the Module Y motor operation to
coordinate movements between SHAPESHIFTER fixtures mounted
160-175
opposite each other vertically.
175-191 These options swap the Module X and Y motor operation to coordinate
movements between SHAPESHIFTER fixtures mounted perpendicular to
192-207
each other
Description
CHAPTER 5
DMX Programming
43