Service Setting - High End Systems Shapeshifter C1 User Manual

Pan Degree
The standard pan range of a SHAPESHIFTER fixture is 0–540°. This option lets you expand the
pan range to an upper limit of 630°.
To expand the pan range, scroll from the default option of 540 to 630 and press the
select.
Encoders
Encoders maintain the Pan and Tilt position of the fixture, but may need to be disabled to perform
certain test and maintenance procedures. The default setting is On. To disable encoders, select
the Off option.
Pan/Tilt Speed
This options adjusts the maximum movement speed of the pan and tilt parameters. The Speed 1
option is the default normal movement speed. Speed 2, Speed 3, and Speed 4 options are
progressively slower maximum movement speeds.
Mic Sensitivity
You can adjust the input level for the internal microphone by setting this option from 0% –99%.
The Default value is 70%.
Hibernation (Standby Mode)
This menu option determines how the fixture will react in the event of DMX data loss.
Turn Hibernation off to keep the shutter open until shutdown by selecting Off.
Scroll to any value from 01M – 99M to set the number of minutes after data loss before closing
the shutter. The default setting is 15M.

Service Setting

Two options for service setting allow you to set a Service PIN or a RDM PID code.
To change the Service PIN:
1. Navigate to and select the Set menu as shown on page 24.
2. Using the
3. Using the
current password will be displayed. The default is Password = 050.
4. Using the
new service password.
Note: A service password must be set before you can enter a six digit RDM PID
number.
SHAPESHIFTER User Manual
buttons, scroll to Status and press the
buttons, scroll to Service PIN and press the
buttons, scroll to a 3-digit number and press the
CHAPTER 3
Menu System
button to select.
button to select. The
button to select as the
button to
25