Pan Degree; Encoders; Pan/Tilt Speed; Mic Sensitivity - High End Systems TechnoArc User Manual

CHAPTER 3
Menu System

Pan Degree

The standard pan range of a Technospot fixture is 0–540°. This option lets you expand the pan
range to an upper limit of 630°.
To expand the pan range, scroll from the default option of 540 to 630 and press the
select.

Encoders

Encoders maintain the Pan and Tilt position of the fixture, but may need to be disabled to perform
certain test and maintenance procedures like optimizing a new lamp.
The default setting is On. To disable encoders, select the Off option.

Pan/Tilt Speed

This options adjusts the maximum movement speed of the pan and tilt parameters. The Speed 1
option is the default normal movement speed. Speed 2, Speed 3, and Speed 4 options are
progressively slower maximum movement speeds.

Mic Sensitivity

You can adjust the input level for the internal microphone by setting this option from 0% –99%.

Hibernation

This menu option determines how the fixture will react in the event of DMX data loss.
Turn Hibernation off to keep the shutter open until shutdown by selecting Off.
Scroll to any value from 01M – 99M to set the number of minutes after data loss before closing
the shutter. The default setting is 15M.

Service Setting

Two options for service setting allow you to set a Service Password or a RDM PID code.
To change the Service Password:
1. Navigate to and select the Set menu as shown on page 29.
2. Using the
3. Using the
current password will be displayed. The default is Password = 050.
4. Using the
the new service password.
Note: A service password must be set before you can enter a six digit RDM PID
number.
30
buttons, scroll to Status and press the
buttons, scroll to Service PIN and press the
buttons, scroll to a 3-digit number and press the
button to select.
button to select. The
button to select as
TechnoArc User Manual
TM
button to