Table of Contents
Advertisement
Chapter 1
Chapter 1
Chapter 1
Chapter 1
Installing the Ecodome
Installing the Ecodome
Installing the Ecodome
Installing the Ecodome
Intended Audience
Ecodome must be installed by a qualified electrician only. This manual is intended for
electricians and/or building contractors already familiar with electrical wiring and
construction.
Unpacking Ecodome
Ecodome ships in three separate boxes—one for the dome, one for the housing, and one
for the base. Carefully unpack each box and inspect the contents for damage. If any of the
items listed in this section are missing or damaged, you must notify both the shipping agent
and your sales agent immediately.
Saving the Shipping Materials
Do not discard the shipping box and packing materials. The box and packing materials are
specifically designed to protect the product during transport.
High End Systems, Inc. assumes no responsibility for products damaged during transport.
Therefore, you should return a product for repair in its original shipping carton and
packing materials.
Note:
Before sending anything to the factory, be sure to call your High End
Systems, Inc. dealer/distributor for a Return Material Authorization (RMA)
number. The factory cannot accept any goods shipped without an RMA
number.
Shipping Ecodome
Ecodome was not designed to be shipped while a fixture
is installed inside Ecodome. If you need to ship
Ecodome to another location, High End Systems, Inc.
strongly recommends you do the following:
1. Remove the fixture installed in Ecodome and repack
the fixture in its original packaging and container.
2. Either disassemble Ecodome and repack it in its
original packaging and containers, or pack the fully
assembled Ecodome in a road case (see Figure 1-1).
®
Ecodome
User Manual
®
to Another Location
®
Base
Base
Base
Base
®
Figure 1-1. Ecodome road case.
Installing the Ecodome
1
®
Base
1-1
Advertisement
Table of Contents
