Alert Mode - Furuno GS-100 Operator's Manual

8. INSTALLATION
4. Enter the value for each item with the numeric keys. Refer to the figure at the right-
hand of the display.
Note: The value for [ANT Position] is more accurate than the value for [CALC-
SPD POSN].
5. Move the cursor to [Enter] then press the ENT key.
6. Press the MENU ESC key to close the main menu.
SOG correction
Note: The [SOG Correction] menu can be set only by a serviceman.
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [1 Correction].
3. Select [6 SOG Correction].
4. Enter the correction value with the numeric keys as follows:
5. Move the cursor to [Enter] then press the ENT key.
6. Press the MENU ESC key to close the main menu.
8.4.8

Alert mode

1. Press the MENU ESC key to open the main menu.
2. Select [3 Alert] then [2 Mode].
3. Select [1 Alert I/F 1], [2 Alert I/F 2] or [3 Legacy].
For [1 Alert I/F 1] or [2 Alert I/F 2], go to step 6.
For [3 Legacy], go to step 4.
[Alert I/F 1]: This system is connected to a device
that outputs the ALR sentence.
[Alert I/F 2]: This system is connected to a bridge alarm system.
[Legacy]: This system is connected to the IF-2503. Set the baud rate to 4800 bps.
(See paragraph 3.9.1.)
4. Select [3 Remote Ack I/F].
5. Select [1 Ack] or [2 Buzzer Stop].
[Ack]: Acknowledge an alert and stop the buzzer.
[Buzzer Stop]: Stop the buzzer.
6. Press the MENU ESC key to close the main menu.
8-18
To switch between + and -, press the cursorpad (◄) to move the cursor
here then press any numeric key.
1) For example, to enter "+10.0%", press the
cursorpad (►) to move the cursor here.
2) Press the 1, 0, 0 keys. The cursor moves
here and "+" appears.