Furuno GS-100 Operator's Manual page 85

4. Enter the offset value with the numeric keys referring to step 5 on
paragraph 7.8.2.
5. Move the cursor to [Enter] then press the ENT key. The message "Processing..."
appears then the last-used screen appears.
Position offset
Note: The [Position Offset] menu can only be set by a serviceman.
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [1 Correction].
3. Select [4 Position Offset].
4. Enter the offset value with the nu-
meric keys. To change the coordi-
nate, select "N" or "E" then press
one of keys from 0 to 9.
5. Move the cursor to [Enter] then
press the ENT key.
6. Press the MENU ESC key to close the main menu.
Ship size and antenna position
Note: The [ShipSize•ANT/CALC-SPD POS] menu can be set only by a serviceman.
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [1 Correction].
3. Select [5 ShipSize•ANT/CALC-SPD POS].
1
2
3
1 : Set the width, length and height of your ship. Enter the values as correct as possible
because these values influence the output sentence "POS". Note that these values
are the upper limits for the values of 2 and 3 .
: Set the mounting location for the antenna unit.
2
X0: The horizontal distance from the reference position "0" to the antenna position.
Y0: The forward distance from the reference position "0" to the antenna position.
Z0: The height from the ship bottom to the antenna unit GS-1001.
: Set the correction of the mounting location for the antenna unit.
3
Y1, Y2: Ship's speed can be measured at two more positions in addition to the
antenna position. Enter the forward distance from the reference position "0" to the
position where you want to measure the ship's speed.
Z: Enter "0" for the height from the transducer, the draft for the heght from the draft.
8. INSTALLATION
8-17