Junction Box - Furuno GS-100 Operator's Manual

8. INSTALLATION
8.3.1

Junction box

Connections
Unfasten four screws to remove the cover, pass the cables through the clamps and
attach the cables to respective connectors. The shield part of the cable (or drain wire)
must lie in the clamp. The terminal opener is attached to the back of the cover.
TB1: 24 VDC
TB2: Display unit
TB3: CAN cable
TB4: Antenna unit
For fishing vessel specifications, fix the cable for the antenna unit to the clamp with
the cable tie (CV-100N).
Fix with cable tie
(CV-100N).
TB4: Antenna unit
Fabrications
ANT-DN18WAPVC-300/400/500 cable
Outer sheath Outer sheath
8-10
100 mm or more 100 mm or more
Vinyl tape Vinyl tape
Inner sheath 1 Inner sheath 1
(Remove outer sheath and inner sheath 2.) (Remove outer sheath and inner sheath 2.)
TB1 TB1
TB2 TB2
TB3 TB3 TB4 TB4
140 mm 140 mm
Pass drain wire through Pass drain wire through
shrink tubing (local supply). shrink tubing (local supply).
TB5 TB5
TB4 TB4
Remove sheath Remove sheath
by 5 to 6 mm. by 5 to 6 mm.