Furuno GS-100 Operator's Manual page 75

Mounting procedure
"Bird-repellent fixtures" (option) can be attached to the sensor cover to prevent birds
from alighting on the cover. If it is more convenient to attach the fixtures before mount-
ing the sensor, do step 8 first.
Note: The mounting procedure differs according to the specification of the antenna
unit.
• For GS-1001-A: Follow steps 1, 2, and 5 to 9.
• For GS-1001-N: Follow steps 1 to 9.
1. As shown in the figure below, weld a platform (local supply) for which to mount the
sensor. The thickness of the platform should be max. 15 mm.
200
160
160
300
2. Connect the sensor cables.
3. Open the cable cover on the bottom of the sensor.
Cable cover
4. Slip the rubber bushing (supplied) onto the sensor cable at the location shown be-
low. Attach the cable to the connector.
Cable clamp
8. INSTALLATION
BOW
Fixing hole (ø11 mm)
Max. 15 mm
Flat washer
Spring washer
Hexagonal nut (M10 SUS316L)
Air vents
DO NOT fill them.
Rubber bushing
Projection (This end
of bushing next to
connector.)
8-7