Beacon/Sbas Menu; How To Select The Offset Information To Use; How To Set Sbas; How To Disable A Satellite - Furuno GS-100 Operator's Manual

3.6

Beacon/SBAS Menu

The Beacon/SBAS menu sets up how to use GNSS or SBAS. (Beacon, that is, beacon
receiver, is reserved for future use.)
3.6.1

How to select the offset information to use

1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then
[3 Beacon/SBAS].
3. Select [1 Mode].
4. Select an option.
[GNSS]: Uses neither beacon nor SBAS for positioning.
[GNSS+SBAS]: Uses SBAS.
5. Press the MENU ESC key to close the main menu.
3.6.2

How to set SBAS

1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [3 Beacon/SBAS].
3. Select [2 SBAS Search].
4. Select [1 Auto] or [2 Manual]. When selecting [1 Auto], the
message "Processing..." appears on the screen. After the pro-
cessing is completed, the screen for SDME or THD appears.
For [2 Manual], go to step 5.
[Auto]: Automatically selects the satellite on the highest elevation among available
satellites.
[Manual]: Selects the satellite manually.
5. Enter the satellite number (setting range:
120 to 138) with the numeric keys.
6. Move the cursor to [Enter] then press the
ENT key.
7. Press the MENU ESC key to close the
main menu.
3.6.3

How to disable a satellite

You can disable up to three satellites.
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [3 Beacon/SBAS].
3. Select [3 Not used Satellite].
3. SETTINGS
3-7