Configuring A Cisco Vpn Device - Motorola AP-7131 Product Reference Manual

Hide thumbs Also See for AP-7131:

Table of Contents

NOTE Ensure the IKE authentication Passphrase is the same as the Pre-shared

to make the changes

18. Check the

automatically refreshes to get the current status of the VPN tunnel. Once the tunnel is

active, the IKE_STATE changes from NOT_CONNECTED to SA_MATURE.

19. On access point #2/ Device #2, repeat the same procedure. However, replace access point

#2 information with access point #1 information.

20. Once both tunnels are established, ping each side of the tunnel to ensure connectivity.

B.2.2 Configuring a Cisco VPN Device

This section includes general instructions for configuring a Cisco PIX Firewall 506 series device.

For the usage scenario described in this section, you will require the following:

• 1 Cisco VPN device

• 1 PC connected to the LAN side of the access point and the Cisco PIX.

NOTE The Cisco PIX device configuration should match the access point VPN

Below is how the access point VPN Status screen should look if the entire configuration is setup

correctly once the VPN tunnel is active. The status field should display "ACTIVE".

key on the Cisco PIX device.

as the IKE Encryption Algorithm.

as the Diffie -Hellman Group. Click OK. This will take you back to the VPN

screen. Notice the status displays "NOT_ACTIVE". This screen

configuration in terms of Local WAN IP (PIX WAN), Remote WAN

Gateway (access point WAN IP), Remote Subnet (access point LAN

Subnet), and the Remote Subnet Mask. The Auto Key Settings and the IKE

Settings on the Cisco PIX should match the access point Key and

IKE settings.

Usage Scenarios