Motorola AP-7131 Product Reference Manual page 222

6-6 AP-7131 Access Point Product Reference Guide
However, selecting any other authetnication or encryption checkbox displays a configuration
field for the selected security scheme within the
NOTE An existing security policy can be edited from the Security Configuration
3. Use the
Remember, multiple WLANs can share the same security policy, so be careful not to name
security policies after specific WLANs or risk defining a WLAN to single policy. Motorola
recommends naming the policy after the attributes of the authentication or encryption type
selected (for example, WPA2 Allow TKIP).
4. Enable and configure an
Manually Pre-Shared
Key / No
Authentication
Kerberos
802.1x EAP
5. Enable and configure an
No Encryption
WEP 64 (40-bit key)
screen by selecting an existing policy and clicking the
Edit Security Policy
editing an existing security policy, refer to security configuration sections
described in steps 4 and 5.
Name field to define a logical security policy name.
Authentication
Select this button to disable authentication. This is the default
value for the
Select the
Configuration
specific information on configuring Kerberos, see
Kerberos Authentication on page
Select the
field within the New Security Policy screen. For specific
information on configuring EAP, see
Authentication on page
Encryption
If No Encryption
security policy. If security is not an issue, this setting avoids the
overhead an encryption protocol causes on the
Encryption is the default value for the Encryption field.
Select the
Settings
information on configuring WEP 64, see
Encryption on page
New Security Policy
screen to edit the policy. For more information on
option if necessary for the target security policy.
Authentication field.
Kerberos button to display the
field within the New Security Policy screen. For
802.1x EAP button to display the
6-11.
option if necessary for the target security policy.
is selected, encryption is disabled for the
WEP 64 (40 bit key) button to display the
field within the New Security Policy screen. For specific
6-16.
screen.
Edit button. Use the
Kerberos
Configuring
6-8.
802.1x EAP Settings
Configuring 802.1x EAP
access point
WEP 64
Configuring WEP
. No