Galley Sink - Pro-Line Boats 32 Express 2010 Owner's Manual

First, wash the area to remove any film that may clog the pads. Start with the
o
Green pad. (Pad color from roughest to smoothest is: White, Yellow, Green,
Peach, Lilac, Blue, Gray.) Rub over scratch in a straight line to remove it.
Periodically switch rubbing direction 90 degrees. Be sure all of the scratch is
removed. If this first step takes too long, try the Yellow pad. To minimize dust
during sanding, wet the surface. Rinse pad periodically to clean residue.
Clean top with water. Inspect to see if scratch was removed. If scratch remains
o
repeat previous step. If scratch is gone, select next finer grit and repeat process.
Rub over a larger area to blend in sanding.
Continue process using successively finer grits until the area blends closely with
o
the surrounding surface gloss. Wash area to remove all sanding dust and
residue. Rinse with clean water and wipe dry.
Note: Refer to sources for materials below to obtain the abrasive pads and other products
mentioned above:

Abrasive Pads

Countertop Magic®

Clean EnCounters®

Deep Cleaner for DuPont Corian®

Enhance Countertop Polish

Green Scotch Brite®

Hope's Countertop Polish

SoftScrub®
For additional information log onto the manufacturer's website at www.corian.com.

Galley Sink

Preventing Damage – In most cases, Staron® can be repaired with ease if accidentally damaged. However, be
sure to follow these guidelines to prevent any damage to Staron®.

Heat damage - Even though Staron® Solid Surfaces have excellent heat resistant property
compared with other ordinary countertops. However, placing hot pans, as well as some heat-
generating appliances such as frying pans or pots can damage the surface. Always use a hot
pad or a trivet with rubber feet to protect Staron®. Avoid long-term exposure of Staron® to
temperatures over 170 degrees F (80 degrees C).

Other Damage - Avoid exposing Staron® Solid Surfaces to strong chemicals such as paint
removers and oven cleaners. Surfaces exposed to these chemicals should be promptly flushed
with water. Prolonged contact will cause spots and require extensive repairs. Do not cut directly
on a Staron® Solid Surfaces surface; always use a cutting board.

Run cold water when pouring boiling water into sinks.

Remove nail polish with a non-acetone based nail polish remover and flush with water.
For more information log onto the manufacturer's website at www.staron.com
NOTE: Any of the above can affect the surface finish and color. Dark colors may require more
maintenance. Staron® 's solid composition makes is easy to maintain because it is homogenous.
The surface can be restored to its original sheen by removing stains and scratches with a
detergent. Periodic maintenance is recommended to retain the surface quality and appearance.
Routine Cleaning – Occasionally clean the surface with soap, water and an ammonia-based cleanser using a
sponge or damp cloth. Towel dry.
To remove severe and difficult stains

Dull finish: Use an abrasive cleanser and a green Scotch-Brite® pad. Rub in a circular motion.

Semi-gloss finish: Use Soft Scrub® cleanser, diluted with bleach and a white Scotch-Brite® pad.
Rub in a circular motion.
Micro-Surface Finishing Products, Inc. @ 800 225-3006
Magic America Corp. @ 800-321-6330
SCI @ 800-839-1654 or The Home Depot
SCI @ 800-839-1654 or The Home Depot
EMS @ 800-643-8818
Local Supermarket or hardware stores
The Hope Co. @ 800-325-4026
Local supermarket
60