Table of Contents
Advertisement
Clean with soft bristle brush.
Allow mixture to soak for up to 20 minutes.
Rinse thoroughly.
Air dry.
Repeat if necessary.
Re-treating the Fabric - Sunbrella fabrics are treated with a fluorocarbon finish to enhance water repellency. This
finish is designed to last for several years, but must be replenished after a thorough cleaning. Based on test
results, Glen Raven recommends
Sunbrella fabrics. Fabrics should be retreated after thorough cleaning or after five years of use. Check with your
local Sunbrella dealer or distributor for additional information.
For more information, visit the Sunbrella website at www.sunbrella.com for specific recommendations.
Isinglass (Windscreen Material)
Maintenance means "rinsing" with cold water and trying not to rub the dirt into the Isinglass. Never "Dry" dust the
Isinglass panels. Any rubbing acts like sandpaper to plastic so keep rubbing to a minimum. Always use lots of
cold water and a very very soft cloth when rubbing is required. Do not use paper towels or Terri-cloth towels. Try
not to use any cleaning solutions, as most will cause yellowing and cracking.
When you have to store the panels of your windscreen and curtain package, always "roll up" the material to
prevent creases. Do not fold the Isinglass as this will permanently damage the Isinglass material. Do not roll up
the panels when wet, as the material will turn white or fog up. Dry the panels off first using a very very soft cloth
before rolling them up. A few hours in the sun will get rid of the whiteness or fogginess in most cases.
Vinyl
Interior Vinyl - Cabin Headliner and Cabin Bolsters
Clean periodically to maintain the appearance of the vinyl and to prevent the build-up of dirt and contaminants.
Any stain, spill or soiling should be cleaned promptly to prevent the possibility of permanent staining. When
cleaning, always scrub gently using a soft cloth or nylon bristle brush.
Caution: Powered abrasives, abrasive cleaners and steel wool will damage vinyl, as do strong
solvents, lacquer solutions and inks. Lotions, suntan oil, waxes and polishes, etc., contain oils
and dyes that can cause stiffening and staining of the vinyl. Never use steam, heat guns or hair
dryers.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner's package for recommended methods to clean specific types of stains.
Exterior Vinyl – Upholstered Seats and Cockpit Bolsters
Vinyl requires periodic cleaning to maintain its neat appearance and to prevent the build-up of dirt and
contaminants that may permanently stain and reduce the life of the vinyl if they are not removed. The frequency
of cleaning depends on the amount of use and on environmental conditions to which the vinyl is subjected. The
procedures used for cleaning are dependent upon the end use circumstances.
For normal cleaning, most stains can be cleaned using warm soapy water and a clear water rinse. Moderate
scrubbing with a medium bristle brush will help to loosen soiling material from the depressions of embossed
surfaces.
For stubborn stains, use either Fantastic or Mr. Clean, which are commercially available mild
detergents, in accordance with manufacturers instructions.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner's package for recommended methods to clean specific types of stains.
303 High Tech Fabric Guard™
as the preferred re-treatment product for
58
Advertisement
Table of Contents
