Table of Contents
Advertisement
1
Accessory - This switch can be used for the optional flat screen television or an additional dealer installed
accessory.
Please check the amp rating of any new component and/or additional accessory before
installation. If you have selected the optional flat screen television, see additional information on this
component in the Cabin Appliances and Accessories section of this manual. This switch is rated for 5
Amps.
2
Cockpit Lights - Your boat is equipped with cockpit/courtesy lights. The lights have LED (light emitting
diode) bulbs with a lifespan of approximately 10,000 hours. To activate the lights, depress the switch to the
up or forward position. The lights give off a soft warm light which should not affect your night vision, but will
still provide you with enough light to move around your cockpit safely in low visibility conditions.
3
Courtesy Light - To activate the cabin courtesy light, which is located behind the cabin stairs, depress the
switch to the up or forward position. This is a LED (light emitting diode) light with an approximate life span
of 10,000 hours. This light should be left on when using the vessel in low visibility conditions. The courtesy
light should have no effect on your night vision. It can also be left on during the night as you would a night-
light.
4
Baitwell Light - To activate the baitwell light, depress the switch to the up or forward position. This will
activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white light that will keep your
bait moving and lively. It will also help you locate your bait on those early morning or late night fishing trips.
To turn the light off, simply depress the switch to the down or aft position.
5
Windshield Vent – The switch that operates the windshield vent is a 3 position momentary switch, which is
only active when the button is depressed. To open the windshield vent, depress and hold the switch to the
up or forward position. Release the switch when the windshield vent reaches the desired position. When
you are ready to close the windshield vent, depress the switch in the down position until the vent window
reaches the desired position. Once the vent has traveled to the full out or full in position, you should
release the switch. See additional information on this component in the Windows, Hatches and Doors
section of this manual.
6
Windshield Wipers – Depressing the switch to the up or forward position activates the starboard windshield
wiper. Depressing the 3 position switch to the down or aft position will activate both the port and starboard
wipers. The center position on the switch is the off position for both wipers. See additional information on
this component in the Windows, Hatches and Doors section of this manual.
7
Navigation and Anchor Lights - Locate the Nav. light switch on the instrument panel. This is a 3-way switch
(forward, middle, back/aft) that functions as follows when you press the switch:
Forward position - Turns on the bow lights and the anchor light. This position will also
activate the red light in your compass.
If you have Faria gauges on the dash panel, this function will illuminate the
o
gauge lights.
If the gauges were provided by the engine manufacturer (i.e., Mercury,
o
Honda, etc.), this switch will not illuminate the gauge lights. Instead, your
gauge lights will be illuminated when the ignition switch is turned on.
Middle position – All lights are off.
Back/Aft position – Anchor light is on; the bow lights and gauge lights are off.
8
Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore. Depress the
horn switch to the up or forward position to activate the horn. Release the horn switch to deactivate the
horn. Using different sequences of horn blasts indicates different and sometimes dangerous situations to
you or someone around you.
Avoid any horn use without an appropriate purpose. See the Safety Section in this manual and/or take a
safe boating course for more information on the proper use of the horn.
9
Cabin Light (Accessory) – This switch can be used for additional dealer installed accessory. Please check
the amp rating of any new component and/or additional accessory before installation. This switch is rated
for 5 amps.
16
Advertisement
Table of Contents
