Table of Contents
Advertisement
Then, turn on the blower switch, which is located next to the AC/DC panel.
Once both switches have been set, go to the air conditioner thermostat
control panel. This panel is installed on the port wall of the cabin in close
proximity to the AC/DC panel.
Press the on/off button on the air conditioner thermostat panel once to
activate the system. Press the fan button to navigate between the various fan
speeds. The up (warmer) and down (cooler) arrow buttons allow you to
control the temperature which is also displayed at the top of the air
conditioner thermostat panel (refer to the manufacturer's owners manual).
The air conditioning thru hull on the side of the boat will be releasing water to
ensure that the air conditioner is running cool.
Note: The air conditioner seacock is located inside the cabin beneath the mid berth. This
seacock must be in the open position to operate the generator.
On/Off
Control indicators for
button
Press to set
the fan speed
(ranges from
1 to 6)
Locate one of your air conditioner vents and feel the air flow to see if the air is cooling. Check to make sure raw
water is being discharged from the boat via the thru hull located on the port side hull nearest the bow. To
maintain proper water flow to the air conditioner, check and clean the seawater strainer by unscrewing the bottom
clear container.
To turn off the air conditioner, press the on/off button. Once the air conditioner is turned off, you may also turn off
the blower switch (if applicable) and the breaker switches for the air conditioner and generator.
The optional air conditioner uses seawater for cooling. The air conditioner seacock is located inside the cabin
beneath the mid berth and a strainer is located between the seacock and the cooling (sea water) pump. Do not
operate the unit if cooling water is not flowing or the pump will be damaged. If the unit fails to cool, inspect the
intake and strainer for blockage. Make sure the seacock is open when in use and closed when not in use.
The seawater cooling system may develop an air lock at high speed
or if the boat is removed from the water. An air lock will cause
cooling water to fail to flow through the system. Open the strainer
to purge air from the system and eliminate the air lock. This should
be done each time the boat is put in the water.
To maintain proper water flow to the conditioner, check and clean
the seawater strainer by unscrewing the bottom clear container.
A/C, fan and heat
Temperatur
e display
Press the up or
down arrow
button to raise
or lower the
temperature
Air conditioner seacock lever (yellow lever at
bottom of photo) is shown in the closed
position
Raw water
pump
Sea water
strainer
29
Advertisement
Table of Contents
